Sunday, May 24, 2020

My layout begins!

Several weeks ago I contacted and model railroad friend of mine, who is a woodworker, and asked if he would cut the wood for my layout. He agreed and to day he dropped off the parts today.

So why did I opt to have someone cut the wood for my benchwork? Well, my benchwork is a bit complicated. Let me explain.

Many years ago I ran across Marshall Stull’s Blog article Modular Design for a Shelf Layout and I really like the ‘C’ design. The down side I did not like the waste of wood in the middle of the ‘C’ and I know some of it can be used for other parts but I still did not like it.

My friend suggested Lap Joints and with the angle required because of the roof line in my new space ( see Trackplans on my website.) the three slanted modules along the top needed to have a slanted angle on the vertical support as shown here
SlantedModule.jpg

While I am confident I could make repeatable cuts on the other three modules I was not so confident on the three slanted modules.
SquareModule.jpg

With the arrival of these parts I will begin assembly and hopefully by the end of June 2020 I will have at least the right three or four modules in place.

My plan is to post on this blog each week. Follow along on my journey.

For information about me check out the About page on this blog.

  1. jana

    Thursday, June 4, 2020 - 20:04:22

    love it

Add comment

Fill out the form below to add your own comments